Flange example sentences

"Flange" Example Sentences

1. I need to replace the flange on my toilet.
2. The flange on the pipe was loose and leaking water.
3. The car muffler was held in place by a flange and two bolts.
4. The welder added a flange to the steel beam for stability.
5. The metal pan had a flange around the edge to prevent spills.
6. The flange on the transmission needed to be tightened.
7. The engine block had a flange where the exhaust manifold connected.
8. The ball bearings were held in place by a flange around the outer race.
9. The PVC pipe had a flange fitting that connected it to the valve.
10. The industrial machine had a flange plate to secure it to the floor.
11. The part was secured with a flange nut and bolt.
12. The shower head had a flange that attached to the wall.
13. The boat propeller was attached to the flange on the drive shaft.
14. The flange on the steel tube was damaged during shipping.
15. The ductwork connected to the HVAC unit with flange fittings.
16. The air compressor had a flange mounted on the motor housing.
17. The water pump had a flange that connected to the engine block.
18. The valve was sealed to the pipe with a rubber flange gasket.
19. The chimney top had a flange that fit over the flue pipe.
20. The flange on the drain pipe was corroded and needed to be replaced.
21. The industrial fan had a flange to connect to the ductwork.
22. The machine shop had a large flange lathe for metal working.
23. The hot water heater tank had a flange for the heating element.
24. The fillet weld around the flange was not up to code.
25. The automotive wheel hub had a flange for the lug nuts.
26. The pressure gauge was attached to the pipeline with a flange connection.
27. The thermocouple probe was inserted into the flange on the reactor.
28. The hydraulic cylinder had a flange mounting bracket for easy installation.
29. The air intake filter housing had a flange to connect to the engine.
30. The electric motor had a flange bolt pattern for mounting to the pump.

Common Phases

- Adding a flange to the pipe joint for extra strength;
- Tightening the bolts on the flange to prevent leaks;
- Removing the old flange and replacing it with a new one;
- Aligning the flange faces to ensure a proper seal;
- Welding the flange to the pipe for a permanent joint;
- Choosing a flange material suitable for the pipeline contents;
- Checking the thickness of the flange to comply with pressure ratings;
- Using a gasket between the flange faces to prevent leaks;
- Lubricating the flange bolts to facilitate tightening;
- Inspecting the flange for corrosion or damage before installation.