Spline example sentences

"Spline" Example Sentences

1. He had to replace the broken spline.
2. The spline joint held the two pieces together.
3. The spline shaft was connected to the motor.
4. He used a special tool to tighten the spline.
5. The spline was inserted into the axle.
6. The spline was made of high-grade steel.
7. He lubricated the spline to reduce friction.
8. The spline was connected to the drive shaft.
9. The spline was the weakest link in the system.
10. He used a wrench to tighten the spline.
11. The spline was damaged by the force of the impact.
12. The spline was made of hardened steel for durability.
13. He had to replace the broken spline to repair the machine.
14. The spline was secured with a locking nut.
15. The spline was inserted into the gearbox.
16. He had to remove the old spline before he could install the new one.
17. The spline was designed to fit the axle perfectly.
18. He used a tool to remove the old spline.
19. The spline was connected to the wheel hub.
20. He had to replace the worn spline to fix the problem.
21. The spline was corroded by the saltwater.
22. The spline was too short to fit the axle.
23. He used a file to smooth the edges of the spline.
24. The spline was made of strong, lightweight aluminum.
25. He had to cut the spline to the correct length.
26. The spline was damaged beyond repair.
27. He had to use a special tool to remove the spline.
28. The spline was secured with a locking pin.
29. The spline was made of a special alloy for extra strength.
30. He had to remove the old spline before he could install the new one.
31. The spline was inserted into the bearing.
32. He had to use a special tool to insert the spline.
33. The spline was too long and had to be cut down.
34. He used a hammer to tap the spline into place.
35. The spline was connected to the crankshaft.
36. He had to replace the worn spline to fix the problem.
37. The spline was made of heat-treated steel for extra strength.
38. He used a wrench to loosen the spline.
39. The spline was inserted into the transmission.
40. He used a file to sharpen the edges of the spline.

Common Phases

smooth;curve;slope;interpolation;tangent;knot;control point;B-spline;spline surface