Circlip example sentences

"Circlip" Example Sentences

1. The circlip holds the bearing in place.
2. He used a circlip to secure the gear onto the shaft.
3. The mechanic replaced the circlip on the brake caliper.
4. The circlip snapped and the piston came loose.
5. The circlip was difficult to remove with pliers.
6. She carefully installed the circlip on the valve stem.
7. The circlip was not seated properly and the drive shaft came loose.
8. The circlip prevented the bearing from sliding out of place.
9. The circlip was too small for the opening and had to be replaced.
10. Without the circlip, the clutch would not engage.
11. The circlip was rusted and needed to be replaced.
12. He inserted the circlip on the end of the cable to prevent fraying.
13. The circlip was a tiny but essential part of the mechanism.
14. The circlip was damaged during shipping and had to be replaced.
15. She carefully positioned the circlip in the groove.
16. The circlip was preventing the axle from seating properly.
17. He used a special tool to install the circlip onto the piston.
18. The circlip was missing from the assembly and had to be located.
19. Without the circlip, the spring would not stay in place.
20. The circlip was a crucial component of the assembly.
21. He inspected the circlip for signs of wear or damage.
22. The circlip needed to be replaced to prevent vibration.
23. She noticed the circlip was loose and tightened it with pliers.
24. Without the circlip, the pin would not stay in place.
25. The circlip was an integral part of the clutch system.
26. He secured the circlip onto the shaft using a retaining ring plier.
27. The circlip was preventing the shaft from turning freely.
28. She aligned the circlip with the groove and pressed it into place.
29. The circlip was too big for the opening and would not fit.
30. Without the circlip, the sprocket would slip on the shaft.

Common Phrases

1. Install the circlip on the shaft;
2. Remove the circlip from the groove;
3. Check the circlip for damage;
4. Replace the circlip with a new one;
5. Properly position the circlip in the groove;
6. Use circlip pliers to securely install the circlip;
7. Lubricate the circlip before installation;
8. Use a circlip remover tool to safely remove the circlip from the groove;
9. Measure the circlip to ensure it is the correct size;
10. Use a circlip spreader tool to expand the circlip for installation.