Disconnector example sentences

"Disconnector" Example Sentences

1. The disconnector on the power panel needs to be replaced.
2. The technician disconnected the faulty disconnector.
3. The disconnector switch was accidentally turned off.
4. You should never tamper with the disconnector without proper training.
5. The electrician identified a problem with the disconnector on the circuit breaker.
6. The disconnector is a critical component in controlling the flow of electricity.
7. The disconnector circuit is designed to shut off power in emergency situations.
8. The disconnector was manually tripped to prevent a potential electrical hazard.
9. The safety protocol requires that the disconnector be locked out before performing maintenance.
10. There was a malfunction in the disconnector mechanism that caused a blackout.
11. The disconnector switch is labeled for easy identification.
12. The disconnector terminal was loose and needed to be tightened.
13. The disconnector fuse was blown and needed to be replaced.
14. The disconnector assembly was inspected and found to be in good condition.
15. The disconnector was not properly grounded, which led to an electrical surge.
16. The disconnector control panel is located in the main electrical room.
17. The disconnector operating handle is color-coded to indicate its function.
18. The disconnector switch was intentionally turned off to de-energize the system.
19. The disconnector housing was cracked and needed to be replaced.
20. The disconnector contact points were worn and needed to be cleaned.
21. The disconnector linkage was lubricated to prevent rust and corrosion.
22. The disconnector was tripped by a fault current in the system.
23. The disconnector limit switch is designed to prevent over-travel.
24. The disconnector busbars were inspected for signs of damage.
25. The disconnector motor was replaced after showing signs of wear.
26. The disconnector was mistakenly left in the "on" position, causing a safety hazard.
27. The disconnector manufacturer is known for producing high-quality electrical components.
28. The disconnector cover was removed to access the internal wiring.
29. The disconnector mechanism is designed to prevent accidental disconnection.
30. The disconnector lockout tagout procedure must be followed at all times.
31. The disconnector control circuit was repaired by an experienced electrician.
32. The disconnector bay was opened to inspect the switchgear assembly.
33. The disconnector interlock prevents the disconnector from being closed when the circuit breaker is closed.
34. The disconnector isolates the equipment from the power source for maintenance.
35. The disconnector was installed to allow for safe and easy operation of the electrical system.
36. The disconnector grounding wires were checked for continuity.
37. The disconnector bypass switch is available for emergency situations.
38. The disconnector contact resistance was measured to ensure proper function.
39. The disconnector solenoid was tested to verify its performance.
40. The disconnector position indicator shows whether the switch is open or closed.

Common Phrases

1. Disconnect the power;
2. Turn off the disconnector;
3. Remove the disconnector;
4. Reconnect the disconnector;
5. Check the status of the disconnector;
6. Maintain the disconnector;
7. Replace the disconnector;
8. Secure the disconnector in place;
9. Troubleshoot the disconnector;
10. Test the disconnector.