Insulation example sentences

"Insulation" Example Sentences

1. We installed fiberglass insulation in the attic.
2. The basement walls needed more insulation against the damp cold.
3. The contractor checked to make sure all the wiring was properly covered by insulation.
4. We blew cellulose insulation into the attic walls and floors.
5. The wind whistling through the gaps in the insulation kept me up all night.
6. The leaking pipes froze because the pipe insulation had deteriorated.
7. The walls and ceilings of older houses often had little or no insulation.
8. Roofers installed thick rolls of insulation between the rafters.
9. The weatherstripping and door sweeps helped improve the overall insulation of the house.
10. Exposed wiring can damage insulation over time.
11. Rock wool insulation was used between the exterior and interior walls for added warmth.
12. We wrapped the water heater and hot water pipes with foam insulation.
13. The sound insulation in the walls blocked out most of the street noise.
14. Blankets used as makeshift insulation kept the rooms somewhat warmer.
15. The builders installed spray foam insulation in all the exterior walls.
16. More insulation was needed under the wood floors to muffle noise.
17. The insulted attic space trapped heat inside during the winter.
18. Thin insulation allowed heat to escape through the old windows.
19. Gaps in the insulation around the chimney let warm air escape.
20. We stuffed insulation into any cracks or holes in the exterior walls.
21. Safety regulations require wire and conduit to have proper insulation.
22. The under-insulated ductwork resulted in cold air leaks throughout the house.
23. New, thicker attic insulation cut heating bills significantly.
24. Pipe insulation prevents condensation from forming on the pipes.
25. Acoustic insulation helped deaden sounds between rooms.
26. Foam gaskets provided extra insulation around the doors.
27. The blower door test revealed several areas lacking proper insulation.
28. Styrofoam boards provided effective insulation for the foundation wall.
29. The city recommended adding exterior insulation to the outer walls.
30. Improved wall insulation also helped regulate interior temperatures.
31. Radiant barriers in attics and crawl spaces added extra insulation.
32. They insulated around every window and door frame for maximum efficiency.
33. Rim joist insulation helped seal air leaks between floors.
34. Knee wall insulation filled cavities between angled walls and ceilings.
35. The spray foam insulation filled every nook and cranny around the windows.
36. Dense-packed cellulose was the most effective type of wall insulation.
37. The builder installed insulation baffles to keep insulation away from heat sources.
38. Blown-in wall insulation settled snuggly around pipes and wiring.
39. Insulation barriers help prevent dirty attic air from circulating inside the house.
40. The layers of heavy insulation muffled all outside sounds.
41. The cost of extra insulation will pay for itself in lower energy bills.
42. The aging insulation had lost most of its insulating properties.
43. The new floor installation included proper sound insulation between floors.
44. Improper installation of attic insulation can decrease its effectiveness.
45. Thick insulation cut down on outside noise from nearby traffic.
46. Fiberglass insulation can irritate skin and cause itching and rashes.
47. The poorly fitted insulation panels let cold air drafts through gaps.
48. Damaged insulation should be replaced immediately.
49. Building code now requires adequate insulation in all new construction.
50. Rigid foam insulation provided the best protection against moisture and air leaks.
51. Condensation formed where the ductwork insulation had deteriorated.
52. Loose-fill insulation was blown into the walls through small holes.
53. The gaps in the wall insulation were allowing bugs and rodents to enter.
54. Vinyl siding made it difficult to access and repair exterior wall insulation.
55. Thick layers of natural wool insulation lined the old log cabin.
56. Densely packed insulation traps more air pockets for better performance.
57. Tiny air pockets in the insulation trap heat or cold to insulate the space.
58. Spray foam insulation filled every tiny crevice and gap for maximum effectiveness.
59. Properly installed insulation can make a huge difference in energy efficiency.
60. The insulation around the water heater finally had to be replaced after 30 years.

Common Phases

1. The builder installed new insulation in the attic to improve energy efficiency.
2. The exposed insulation in the basement made it difficult to heat the house properly.
3. We need thicker insulation to keep the heating costs down during the cold winter months.
4. Rolls of fiberglass insulation were stacked in the corner of the garage.
5. The builders recommended upgrading the old insulation under the floors and in the walls.
6. The inspector checked the condition and effectiveness of the home's insulation.
7. The new sound insulation helped reduce noise from outside traffic.
8. The moisture accumulated when the insulation failed to keep the pipes from freezing.
9. Most modern homes use fiberglass batt insulation between the walls and in the attics.
10. The loose insulation made it difficult to walk through the dusty, unfinished attic space.
11. Spray foam insulation provides superior thermal and sound insulation for walls and roofs.
12. The insulation around the pool pipes helped prevent them from freezing during winter.
13. We need more fiberglass insulation blown into our attic to make it warm during winter.
14. Densely packed cellulose insulation was blown into the walls of the old house.
15. The blown-in insulation settled at the bottom of the attic after a few years.
16. The moisture barrier separated the insulation from the concrete foundation.
17. The electricians had to move the insulation to access the wiring in the walls.
18. Contractors cut openings in the insulation for installing lights and exhaust fans.
19. We installed thicker rock wool insulation in the attic to keep out sound from the street.
20. The damaged insulation around the windows allowed heat to escape from the house.
21. The dryer vent and bathroom exhaust fans need insulation and weatherstripping.
22. Plugging small holes and cracks helped retain the effectiveness of the wall insulation.
23. Insulation between floors worked to minimize sound transmission between rooms.
24. Excess insulation was packed into any empty spaces found in the walls and attic.
25. The contractor checked for gaps and compression in the existing insulation.
26. The windows needed additional weatherstripping and caulk to work with the insulation.
27. A vapor barrier was placed over the insulation to protect it from moisture.
28. The damaged insulation around the fireplace chimney needed to be replaced.
29. The inspector found areas where the insulation was compressed or out of place.
30. Additional insulation was blown into the attic after new rafters were installed.
31. The existing insulation was removed before rewiring the outdated electrical system.
32. The lack of insulation around the water pipes caused them to freeze during winter.
33. Insulation was stuffed into any gaps or cavities found around windows and doors.
34. The builder installed separate layers of insulation in the walls for optimal efficiency.
35. Extra insulation was added around floor joists and wall cavities near exterior walls.
36. The utility room needed additional insulation to keep pipes from freezing.
37. Insulation batts were secured between the wall studs with wire clips.
38. The old fiberglass insulation was stained and falling apart due to age.
39. The inspector recommended adding vapor barriers over the old insulation in the attic.
40. Additional insulation was added to the underside of the flooring for sound abatement.
41. The exposed fiberglass insulation itched and caused irritation without proper protection.
42. Contractors built channels within the wall cavities to install insulation properly.
43. The loose insulation needed to be compressed and shaped around existing wiring.
44. The inspector checked for insulation around any concealed piping or ductwork.
45. Spray foam insulation was used to fill any irregularly shaped spaces within the home.
46. Exposed insulation near lights and outlets presented a fire hazard.
47. The rats and mice made nests out of the loose insulation in the unfinished basement.
48. The moisture barrier separated the insulation from the concrete foundation walls.
49. The chemical exposure caused the foam insulation to break down over time.
50. Additional mineral wool insulation was added to the walls of the garage.
51. The inspector checked that all recessed lights were properly insulated.
52. Contractors will be installing spray foam insulation behind the stone facade.
53. The installer preserved the existing insulation when adding new electrical wiring.
54. The insulation helped control indoor humidity levels during the summer months.
55. The cracks and gaps in the old stone walls needed additional insulation.
56. The inspector checked all areas where plumbing and wiring enter the home for insulation.
57. The installers wore protective masks, gloves and clothing to avoid contact with the insulation.
58. The insulation was properly shaped and fitted around existing obstructions in the walls.
59. The holes in the vapor barrier allowed moisture to penetrate the exposed insulation.
60. The inspector recommended having the insulation around the ductwork replaced.