Molality example sentences

"Molality" Example Sentences

1. The molality of the solution was calculated to be 2.5.
2. Increasing the molality of the solute will increase the boiling point of the solution.
3. Molality is a measure of concentration that involves the mass of the solvent.
4. The molality of the solution was too low to have any significant effect on the colligative properties.
5. The molality of a solution is determined by dividing the mass of the solute by the mass of the solvent.
6. The molality of the solution was found to be 1.5 moles per kilogram of solvent.
7. The molality of a solution is a more accurate measure of concentration than molarity.
8. The molality of a solution can be calculated using the formula m = n solute / mass solvent.
9. The molality of the solute in the solution was 0.5 moles per kilogram of water.
10. The molality of a solution is independent of temperature and pressure.
11. Solutions with higher molality values will have greater viscosity than those with lower molality values.
12. The molality of the solution affects the freezing point depression and boiling point elevation.
13. Knowing the molality of a solution is important in preparing solutions with a specific concentration.
14. The molality of the solution was too high for it to be considered a dilute solution.
15. The molality of the solute is a limiting factor for the solute's solubility in the solvent.
16. The molality of the solution can be used to determine the osmotic pressure of the solution.
17. The molality of a solution can be converted to molarity by dividing by the solute's molar mass.
18. When the molality of the solute in the solution is zero, the solution is said to be a pure solvent.
19. The molality of a solution can be used to determine the vapor pressure of the solution.
20. The molality of the solution was too low to cause any significant depression of the freezing point.
21. The molality of the solute in the solution determines the number of particles present in the solution.
22. The molality of the solution was determined using a hydrometer to measure the density of the solution.
23. The molality of a solution can be affected by changes in temperature and pressure.
24. The molality of a solution can be used to determine the activity coefficient of the solution.
25. Increasing the molality of the solute will decrease the ideal gas law constant of the solution.
26. The molality of the solute in the solution was found to be 3.0 moles per kilogram of ethanol.
27. The molality of the solution was sufficient to cause the solute to precipitate out of the solution.
28. The molality of a solution can be used to determine the solute's distribution coefficient between two phases.
29. The molality of the solute in the solution was calculated to be 0.75 moles per kilogram of benzene.
30. The molality of the solution was too high for the solution to be considered a dilute solution.

Common Phrases

1. The molality of a solution is calculated by dividing the moles of solute by the mass of the solvent in kilograms;
2. Molality is a useful way to express the concentration of a solution because it's independent of temperature changes;
3. Molality is sometimes preferred over molarity because it takes into account changes in volume that occur due to temperature changes;
4. The boiling point elevation and freezing point depression of a solution depend on its molality;
5. Molality can be used to calculate colligative properties such as osmotic pressure and vapor pressure lowering.