Pipename example sentences

"Pipename" Example Sentences

1. The pipename was clogged and there was no water supply.
2. The plumber had to replace the old pipename with a new one.
3. The house had a complex network of pipenames running underground.
4. A strange noise was coming from the pipename that connected to the bathroom sink.
5. The construction workers had to dig up the ground to access the pipename.
6. The pipename was rusted and leaking causing damage to the house's foundation.
7. The water pressure was low due to a blockage in the main pipename.
8. The repairman used a camera to inspect the inside of the pipename.
9. The water filter was attached to the pipename to ensure clean drinking water.
10. The pipename system was designed to provide water to each apartment in the building.
11. The company had to order a replacement valve for the pipename.
12. The pipename was so old that it needed to be replaced entirely.
13. The workers were able to fix the broken pipename without causing further damage.
14. The pipename was used to transport gas to the power plant.
15. The pipename that connected to the sewage system was blocked by debris.
16. The pipe burst, leaving a huge hole in the middle of the road, where the pipename was located.
17. The plumber suggested installing a lift and shift pump to increase the flow of water in the pipename.
18. The pipename was made of PVC, which made it lightweight and easy to install.
19. The engineer noticed a crack in the pipename, which could cause a major leak.
20. The pipename was insulated to prevent freezing during the winter.
21. The leak was coming from a joint that connected two sections of the pipename.
22. The water bill was high due to a leak in the pipename.
23. The pipename ruptured, causing a flood in the basement.
24. The workers had to expose the pipename to repair the broken joint.
25. The pipename was buried under several layers of concrete, making it difficult to access in case of maintenance.
26. The pipename was damaged by a fallen tree during a storm.
27. The plumber traced the blockage in the pipename to a piece of cloth stuck inside.
28. The maintenance crew had to shut off the water supply to fix the pipename.
29. The fire department had to cut through the pipename to rescue a kitten trapped inside.
30. The new building was being constructed with a modern pipename system, unlike the old building.

Common Phases

1. Creating a new pipename
2. Opening an existing pipename
3. Reading data from pipename
4. Writing data to pipename
5. Closing the pipename
6. Removing the pipename