Torques example sentences

"Torques" Example Sentences

1. The torque required to turn the wheel was high.
2. The torque wrench was used to tighten the bolts.
3. The engine produced a maximum torque of 300 Nm.
4. The torque converter is a component of the automatic transmission.
5. The torque sensor measured the twist in the shaft.
6. The torque specifications were provided in the manual.
7. The electric motor produced a high torque at low speeds.
8. The torque steer in the car was noticeable when accelerating.
9. The torque curve showed the relationship between torque and engine speed.
10. The torque limiter protected the transmission from overloading.
11. The torque vectoring system redistributed power to the wheels for better handling.
12. The torque sensor was used to calibrate the power output of the engine.
13. The torque thrust wheels had a distinctive design.
14. The torque sensor helped adjust the amount of force needed to rotate the shaft.
15. The torque applied to the bolt was too low, causing the joint to loosen.
16. The torque meter displayed the torque of the shaft in real-time.
17. The torque feedback system helped control the robotic arm's movements.
18. The torque converter clutch engaged to provide direct drive and reduce slipping.
19. The torque ratio of the gears affected the speed and power of the machine.
20. The torque sensor was a critical component of the wind turbine.
21. The torque wrench clicked when the correct torque was achieved.
22. The torque controller adjusted the power output of the motor based on the load.
23. The torque sensor measured the twisting force on the crankshaft.
24. The torque ripple in the motor caused vibrations and noise.
25. The torque curve showed the optimal range of power for the engine.
26. The torque vectoring differential improved traction and handling in the car.
27. The torque converter was designed to transmit power smoothly between the engine and transmission.
28. The torque tube helped transfer power from the engine to the rear axle in the car.
29. The torque specifications were different for each size of bolt.
30. The torque sensor was calibrated to ensure accurate readings.

Common Phrases

1. The torques applied by the motors were carefully calibrated;
2. Without enough torque, the drive shaft would not turn;
3. The torque converter allowed for increased power transfer;
4. Adjusting the torque settings could improve performance;
5. The torque specification needed to be checked before assembly;
6. Calculating the torque value required precise measurements;
7. The torque wrench ensured accurate tightening of bolts;
8. The torque feedback system provided real-time data to the operator;
9. The torque curve demonstrated the engine's power output over RPMs;
10. The torque limiter prevented damage to the machinery.