Amperes example sentences

"Amperes" Example Sentences

1. The current flowing through the circuit is measured in amperes.
2. The light bulb requires 0.5 amperes of current to operate.
3. The motor draws 10 amperes of current at maximum load.
4. It is important to use the correct fuse rating in amperes for safety.
5. The power supply can deliver up to 5 amperes of current.
6. The conductor is rated for 20 amperes of current before overheating.
7. The electrician measured the amperes to diagnose the problem.
8. I need to convert watts to amperes to determine the circuit requirements.
9. The amperes are too high for this wire size, causing a fire hazard.
10. The maximum amperes of the circuit breaker must be higher than the load.
11. The current sensor can measure up to 50 amperes accurately.
12. The amperes draw by the appliances exceeded the capacity of the generator.
13. The power supply is rated for 10 amperes at 120 volts.
14. The amperes of the battery decrease as it nears the end of its life.
15. The electrician measured the voltage and amperes to calculate the power.
16. The resistance of the circuit determines the amperes at a given voltage.
17. The motor requires a minimum of 5 amperes to start and run properly.
18. The amperes drawn by the machine vary depending on the load.
19. The circuit breaker tripped due to the amperes exceeding its limit.
20. The amperes flowing through the wire can be affected by its length and width.
21. The gauge of the wire should be chosen based on the expected amperes.
22. The use of a transformer can increase or decrease the amperes of a circuit.
23. The amperes drawn by the device can be reduced by using a more efficient design.
24. The amperes flowing through the battery can be monitored using a battery monitor.
25. The maximum amperes of the power source must be higher than the maximum load.
26. The amperes of the electric motor can be adjusted using a variable frequency drive.
27. The amperes of the circuit increase as more resistors are added to the circuit.
28. The overload protection circuitry ensures that the amperes do not exceed safe levels.
29. The overcurrent protection prevents the amperes from exceeding the rated limit.
30. The amperes of the circuit can be limited by using a current limiting resistor.