"Buret" Example Sentences
1. The buret is a laboratory instrument used for accurate titration.
2. She filled the buret with a sodium hydroxide solution.
3. The buret was calibrated before any measurements were taken.
4. A buret clamp was used to secure the buret to the titration stand.
5. The buret was marked at every 0.1 mL to improve precision.
6. A buret reading can be tricky if you're not used to it.
7. The buret was rinsed with distilled water before use.
8. The buret stopcock was slowly opened to release the titrant.
9. The buret holder keeps the buret from falling during the experiment.
10. The buret tip should be placed just above the meniscus to avoid errors.
11. The buret was shaken to ensure that the titrant was well mixed.
12. Acetic acid was added slowly to the flask until the buret reading showed equivalence point.
13. The buret was placed at a 45-degree angle to prevent air bubbles.
14. The buret burette has a glass tube with a fine tip to precisely release small amounts of liquid.
15. She carefully recorded the buret reading after each titration.
16. The buret was essential to determining the concentration of the unknown solution.
17. A buret is typically used in acid-base titrations.
18. The buret was cleaned with a solution of potassium permanganate.
19. The buret stand held the buret in place while the titration was performed.
20. A buret is commonly used in analytical chemistry.
21. The buret was emptied after each trial to avoid contamination.
22. The buret was used to deliver a specific volume of titrant.
23. The buret was calibrated against a solution of known concentration.
24. The buret was used to accurately dispense the reagents.
25. The buret was refilled with the titrant solution after every titration.
26. A buret stopper was placed in the top of the buret to prevent evaporation.
27. The buret tip was cleaned with a lint-free cloth to avoid contamination.
28. The buret was held vertically while filling to ensure accurate measurement.
29. The buret was attached to a buret holder during the titration process.
30. The buret was drained completely at the end of the experiment.
Common Phases
1. Measure the volume of the solution using a
buret;
2. Add the solution drop by drop to the reaction mixture using a
buret;
3. Rinse the
buret thoroughly with distilled water before use;
4. Calibrate the
buret using a standard solution before use;
5. Record the initial and final
buret readings to determine the volume of solution used;
6. Use a
buret clamp to secure the
buret in place during use;
7. Adjust the flow rate of the solution by carefully opening or closing the
buret stopcock;
8. Titrate the solution with an acid or base using a
buret to determine its concentration;
9. Remove any air bubbles in the
buret by tapping it gently;
10. Clean the
buret with soap and water after use.