"Circuitor" Example Sentences
1. The electrician repaired the faulty circuitor in the building.
2. The circuitor in the computer's motherboard was malfunctioning.
3. The engineer tested the circuitor connections before installing the machine.
4. The technician replaced the old circuitor with a new one to fix the problem.
5. The manufacturer designed a specialized circuitor for the medical equipment.
6. The circuitor board in the elevator was causing frequent breakdowns.
7. The electrician traced the wiring to find the faulty circuitor.
8. The repairman ordered a replacement circuitor from the supplier.
9. The circuitor in the car's ignition system needed rewiring.
10. The technician programmed the circuitor to operate at a higher frequency.
11. The repairman discovered a loose circuitor connection that was causing the issue.
12. The circuitor design was revised to improve efficiency.
13. The installation of the new circuitor was completed successfully.
14. The computer system shut down due to a faulty circuitor.
15. The circuitor manufacturer provided a warranty for their products.
16. The electrician installed a surge protector to prevent damage to the circuitor.
17. The circuitor's overcurrent protection feature prevented a potential disaster.
18. The capacitors in the circuitor were replaced to improve energy storage.
19. The technician repaired the fried circuitor on the power supply unit.
20. The circuitor's fuse blew due to a power surge.
21. The faulty circuitor caused the entire electronic system to fail.
22. The circuitor's resistance was measured using a multimeter.
23. The circuitor diagram was used to identify the various components.
24. The circuitor was tested for electromagnetic interference.
25. The circuitor's impedance was adjusted to match the frequency of the signal.
26. The circuitor's output voltage was regulated to prevent damage to the components.
27. The circuitor fault was attributed to a faulty diode.
28. The repairman replaced the faulty circuitor with a high-quality one from a reputable brand.
29. The circuitor's noise level was reduced by adding shielding.
30. The circuitor's oscillation was stabilized by adding a feedback mechanism.
Common Phases
1. The
circuitor will check the power supply;
2. We need a
circuitor to test this circuit;
3. The
circuitor is used to diagnose issues in electronics;
4. The
circuitor can detect faulty connections;
5. It's important to use a reliable
circuitor to test electrical equipment.