Ejector example sentences

"Ejector" Example Sentences

1. The ejector pin on the mold was stuck.
2. The ejector seat was activated in an emergency.
3. He had to use an ejector rod to clear the barrel.
4. The ejector spring was broken and needed to be replaced.
5. The ejector mechanism was jammed and had to be repaired.
6. The ejector lever had to be adjusted for the correct pressure.
7. The ejector pin was too short and had to be replaced.
8. The ejector rod was bent and needed to be straightened.
9. The ejector seat was tested for proper operation.
10. The ejector spring was tested for proper tension.
11. The ejector pin was checked for proper alignment.
12. The ejector plate had to be adjusted for the right pressure.
13. The ejector system had to be recalibrated for optimal performance.
14. The ejector pin had to be replaced to ensure proper operation.
15. The ejector spring had to be adjusted to the correct tension.
16. The ejector pin had to be lubricated to prevent sticking.
17. The ejector seat had to be tested before each flight.
18. The ejector plate had to be replaced due to wear and tear.
19. The ejector rod had to be adjusted for the correct pressure.
20. The ejector pin had to be replaced due to wear and tear.
21. The ejector lever had to be lubricated to prevent sticking.
22. The ejector spring was adjusted to the correct tension.
23. The ejector system was recalibrated for optimal performance.
24. The ejector pin was lubricated to prevent sticking.
25. He had to use an ejector rod to clear the chamber.
26. The ejector system was tested for proper operation.
27. The ejector lever was adjusted for the correct pressure.
28. The ejector pin was adjusted for the right pressure.
29. The ejector plate was replaced due to wear and tear.
30. The ejector spring was adjusted for the right tension.
31. The ejector mechanism was tested for proper operation.
32. The ejector seat had to be recalibrated for optimal performance.
33. He had to use an ejector rod to clear the blockage.
34. The ejector lever had to be adjusted to the correct pressure.
35. The ejector plate had to be lubricated to prevent sticking.
36. The ejector seat had to be recalibrated for the correct pressure.
37. The ejector spring was checked for proper tension.
38. The ejector pin had to be adjusted for the right pressure.
39. The ejector system was tested for proper functioning.
40. He had to use an ejector rod to clear the obstruction.

Common Phrases

1. Designing the Ejector;
2. Installing the Ejector;
3. Testing the Ejector;
4. Troubleshooting the Ejector;
5. Maintaining the Ejector;
6. Replacing the Ejector.