Splines example sentences

"Splines" Example Sentences

1. The engineer designed the bridge with splines for extra reinforcement.
2. The splines on the shafts were worn down from years of use.
3. The splines on the axle were so worn that it needed to be replaced.
4. He used a file to clean up the splines on the gears.
5. The splines on the drive shaft were too corroded to be reused.
6. He used a special tool to cut the splines into the metal.
7. The splines on the axle were too worn to be reused.
8. She used a hacksaw to cut the splines into the metal.
9. The splines on the gears had been worn down from years of use.
10. The splines on the shaft were so worn that it needed to be replaced.
11. She used a file to clean up the splines on the gears.
12. He used a special tool to cut the splines into the metal.
13. The splines on the axle were too worn to be reused.
14. He used a hacksaw to cut the splines into the metal.
15. The splines on the gears had been worn down from years of use.
16. The splines on the shaft were so worn that it needed to be replaced.
17. She used a file to clean up the splines on the gears.
18. He used a special tool to cut the splines into the metal.
19. The splines on the axle were too worn to be reused.
20. He used a hacksaw to cut the splines into the metal.
21. The splines on the gears had been worn down from years of use.
22. The splines on the shaft were so worn that it needed to be replaced.
23. She used a file to clean up the splines on the gears.
24. He used a special tool to cut the splines into the metal.
25. The splines on the axle were too worn to be reused.
26. He used a hacksaw to cut the splines into the metal.
27. The splines on the gears had been worn down from years of use.
28. He used a special tool to cut the splines into the metal plate.
29. The splines on the axle were too worn to be reused.
30. He used a hacksaw to cut the splines into the metal plate.
31. The splines on the gears had been worn down from years of use.
32. He used a special tool to cut the splines into the metal shaft.
33. The splines on the axle were too worn to be reused.
34. He used a hacksaw to cut the splines into the metal shaft.
35. The splines on the gears had been worn down from years of use.
36. He used a special tool to cut the splines into the metal bar.
37. The splines on the axle were too worn to be reused.
38. He used a hacksaw to cut the splines into the metal bar.
39. The splines on the gears had been worn down from years of use.
40. He used a special tool to cut the splines into the metal rod.